Rob's WD16H and Big4 Forum

One of first 500 of contract C14498 with leg shields

Rob's WD16H and Big4 Forum
Start a New Topic 
Author
Comment
View Entire Thread
Re: My finish engine video have a look

That's sounds great Dave, and looks good too
I see your down pipe has ended up nowhere near the mounting bolt at the front of the engine. No one seems to make a pipe that fits these days

Re: My finish engine video have a look

Yes I'm looking for a old one from somewhere

Re: My finish engine video have a look

I think your pipe needs to come up a bit, I had the same problem with mine. It fitted a lot better when I cut about 3/4" off at the head. I still needed a small spacer to get the clamp onto the bar, I might have got it closer by cutting a tiny bit more off but didn't want to risk cutting it too much. You might have to click on the picture to see it properly.

 photo IMAG2680_zps65029d0d.jpg

 photo 16HEngineampGearbox_zps07a7d244.jpg

 photo 16HatNormandy_zpsfa40ce26.jpg

Re: My finish engine video have a look

That looks very good 😊 that does

Re: My finish engine video have a look

Brilliant job. Idles more reliably than my old heap. Is the magdyno chain a bit tight though?